Article catalogue:
- 1 、What are the precautions for using a fully automatic packing machine?
- 2 、What are the safety protection measures for German iron scrap press
- 3 、Pressure regulating method of 125t hydraulic Metal Packer
What are the precautions for using a fully automatic packing machine?
The first is the precautions for the use of the machine:
1. The operation panel of the machine must not be opened while the machine is running. if it comes into contact with the driving part, it will cause the risk of injury.
two。 In the operation of the machine, we should not touch the exposed parts with our hands to avoid danger.
3. During the operation of the machine, the safety cover and operation panel of the machine must not be removed so as not to cause personal danger.
4. The machine must not touch the running part of the machine in the course of operation, so as to avoid danger.
5. When the machine is running at high speed, our staff should not touch the heater to prevent burns.
6. During the operation of the machine, do not put your hand into the strap to avoid injury caused by being tied up by the strap.
7. In the case of thunder in rainy days, it is best to cut off the power supply, pull the plug, do not run the machine, so as not to cause damage to the machine.
8. The best weight of the packing bundled by the machine is below 80kg.
9. When packing, the packaging should be handled gently to avoid damage to the operation panel of the machine.
10. With regard to the repair and adjustment of the machine, we must invite professional maintenance personnel to carry out maintenance.
The second is the installation method of packing belt:
Before using it, we must make sure that the type of packing belt is in line with the use of our machine. when packing the belt, we first turn off the power supply, then make sure that the machine returns to the origin, and then turn off the power supply. install the packing belt clockwise on the axle and tighten the handle. Open the door of the storage box, then wear the belt, close the door of the storage box, turn on the power machine and automatically send the packing belt into the storage box.
What are the safety protection measures for German iron scrap press
1. The form of safe start-up device: when the operator enters the dangerous area, the clutch in the metal press will not close or the slider cannot go down, and the hydraulic press can carry out these actions only after the operator has completely withdrawn from the dangerous area.
2. the form of mechanical protective device: when the slider goes down, separate the dangerous area from the hands of the operator to ensure safe production.
3. Dynamic protection device: a light beam is set around the stamping die. Once the operator enters the dangerous area, the metal pressing machine can stop working automatically through the control of electricity and gas to protect the safety of the operator.
Pressure regulating method of 125t hydraulic Metal Packer
Adjust the pressure relay.
Through the inquiry of the safe operation rules of the metal packing hydraulic press, it can be known that the pressure adjustment of the 125 ton hydraulic metal packing machine is maintained according to the adjusting pressure relay, which is the general name of the high pressure relay and the low pressure relay. It is composed of the high pressure part of the exhaust pipe pressure control and the low pressure part of the respiratory pressure control.
Hydraulic pressure is a term in machinery industry and mechanical and electrical industry. Hydraulic pressure can be driven by power, which is called hydraulic transmission.
This is the end of the introduction of the safe operation procedures of the metal packing press and the video of the metal press unpacking machine. I wonder if you have found the information you need? If you want to know more about this, remember to collect and follow this site.