A list of the contents of this article:
- 1 、The one in the sealing machine, how to install the adhesive tape?
- 2 、How to load the adhesive tape in the sealing machine? How to adjust the length?
- 3 、How to install the tape in the effective box sealer
- 4 、How to install the tape of automatic box sealing machine
The one in the sealing machine, how to install the adhesive tape?
1. Take apart the adhesive tape first. Put your head at the cut.
2. Put the adhesive tape in the circle in the middle of the sealing machine. But don’t stick the glue side to the sealing machine and put it away.
Under normal circumstances, do not pull out so much, as long as it is enough to cut, so that the glue head is always in the gear.
For more product information, please consult us at FEITA Electronic tools.
How to load the adhesive tape in the sealing machine? How to adjust the length?
Sealing machine packing tape
Install the tape on the mandrel of the sealing machine
The tape needs to be pulled out (the adhesive surface of the tape we pull out must face out)
Is to pull the tape around the knurled sleeve in the movement, and then continue to pass the tape through the sleeve.
Continue to wrap the tape around the knurled sleeve after passing through the sleeve
The sealing machine core piercing process is completed by wearing the tape from the black steel inner sleeve, but the final process needs to be paid attention to in the wearing process, and the operator should be careful to seal the cutter to prevent the cutting accident. The specific wearing process is shown in the following figure.
Adjusting the length of adhesive tape of box sealing machine
First of all, put the tape roll of the new sealing machine into the mandrel, as shown in the picture, second, pull out the tape, bypass drum C and then bypass drum B, third, bypass drum D, and finally pass the tape through tape holder E through drum F, as shown in the following figure. In the whole process, it must be noted that the sticky side of the tape must face outward.
2. The tape piercing diagram is shown in the figure:
3. Adjust the orientation of the tape as shown in the figure:
If the tape is not on the centerline of the box, please refer to the following picture: loosen nut B, then adjust the mandrel with a screwdriver, and then adjust the orientation of the tape.
4. Adjust the tape tension as shown in the figure:
By rotating the knob, the speed of the tape coil can be moderate, the nut M8 can be loosened, the front and rear orientation of the screw M8 × 50 can be adjusted, the elastic force of the long tension spring of the pendulum bar can be changed, and then the tension of the tape can be controlled. When the knob is rotated clockwise, the tape tension becomes larger, and vice versa; when the screw M8 × 50 is adjusted forward, the tape tension increases, and vice versa.
How to install the tape in the effective box sealer
Steps for installing adhesive tape in the box sealer:
1. First, install the tape reel on the belt seat of the upper and lower movement according to the operation on the diagram, so that the glue surface is facing the direction of entering the box.
2. Then the back glue surface is bypassed by the guide belt idler wheel, and after the glue surface bypasses the unidirectional copper wheel, it is necessary to keep the glue facing the direction of the box between the top line and the rubber wheel.
How to install the tape of automatic box sealing machine
It is recommended that users install it in accordance with the instructions, or find a manufacturer to install it. Do not install it casually so as not to damage it without warranty.
This is the end of the introduction on how to change the tape of the automatic box sealing machine. I wonder if you have found the information you need? If you want to know more about this, remember to collect and follow this site.